GE Ohmeda-Datex S5 Patient Monitor IBP Pressure Module Datex-EngStrom MN4F 887464-6

Характер продукции

GE Datex-Ohmeda S5 IBP Module Features

• Dual-Channel IBP Monitoring
  Supports up to two invasive blood pressure channels (e.g., ART, CVP, PA), allowing simultaneous measurement of different pressure types.

• High Accuracy and Sensitivity
  Provides precise pressure readings with high sensitivity for critical care applications.

• Real-Time Waveform Display
  Displays continuous pressure waveforms on the monitor screen for live clinical assessment.

• Customizable Labeling
  Pressure channels can be labeled according to clinical need (e.g., ART, CVP, ICP) for easy identification.

• Compatibility with Standard Transducers
  Supports a wide range of industry-standard disposable or reusable pressure transducers.

• Zeroing Function
  Includes manual zeroing functionality to calibrate the transducer and ensure accurate measurements.

• Integrated with S5 Monitor System
  Seamlessly integrates with the GE Datex-Ohmeda S5 monitor, sharing data with central monitoring and record systems.

• Compact and Modular Design
  Hot-swappable and modular, allowing easy installation, replacement, or service without shutting down the entire system.

• Pressure Range and Display
  Wide measurement range (typically -50 to +300 mmHg) with configurable units and display scaling.

• Alarm and Trend Features
  Programmable high/low pressure alarms and long-term trend recording for patient monitoring and analysis.

• Digital Signal Processing
  Uses advanced DSP for noise reduction and accurate waveform generation.

• Electrical Isolation for Patient Safety
  Designed with high electrical isolation to protect patients and ensure system reliability.

Precautions for Using GE Datex-Ohmeda S5 IBP Module

• Use Compatible Pressure Transducers
  Always use transducers that are approved and compatible with the S5 monitor system to ensure accurate readings.

• Perform Zeroing Before Use
  Always zero the pressure transducer with the stopcock open to air and at the level of the measurement site (e.g., heart level) before taking measurements.

• Avoid Air Bubbles in the Line
  Ensure the pressure line is free of air bubbles, as they can distort waveforms and lead to inaccurate readings.

• Secure All Connections
  Make sure all pressure tubing and electrical connections are tight and secure to prevent leaks or signal loss.

• Label Pressure Channels Correctly
  Always label and confirm the correct pressure type (e.g., ART, CVP, PA) for each channel to avoid clinical misinterpretation.

• Monitor for Infection Control
  Use sterile techniques when connecting pressure lines to the patient. Replace transducers and tubing according to hospital infection control policy.

• Do Not Touch Electrical Contacts
  Avoid touching the electrical connectors on the module or cable ends to prevent contamination or electrostatic damage.

• Check for Module Recognition
  After inserting the IBP module into the S5 monitor, verify that the system recognizes the module and displays the correct parameters.

• Avoid Excessive Pressure
  Do not apply excessive pressure to the transducer or tubing to prevent equipment damage or patient injury.

• Use Electrical Isolation Equipment if Required
  If connecting to other devices, ensure proper electrical isolation to maintain patient safety and avoid ground loops.

• Clean According to Manufacturer Guidelines
  Clean and disinfect the module and cables according to GE’s instructions to maintain hygiene and extend equipment life.

• Remove Module Properly
  When removing the IBP module, do so gently to avoid damaging the connector pins or internal circuitry.

• Verify Alarms and Limits
  Always set and verify alarm limits appropriate to the patient’s condition to ensure timely clinical response.